Topics:

• How to remove the drawer in a Designer (IT, ID) unit
• Can the entire drawer on a Designer Tall or Drawer model be removed?

Troubleshooting:

Upper Drawer Removal

1. Pull the upper drawer assembly open fully.
2. Lift the front of the drawer up and off of tabs at front end of the drawer spacers.
3. Push the telescoping drawer slide assemblies back in.
4. Carefully place the drawer assembly face-down directly in front of unit.
5. Disconnect the control cable at the interior left rear of the unit. To do so, turn the collar on the connector counterclockwise and unplug the pins from the socket (ID models only).

Lower Drawer Removal

1. Pull the lower drawer assembly open.
2. Lift the front of drawer up and off of the tabs at front end of the drawer spacers.
3. Pull the drawer assembly forward and off of the drawer slides.
4. Push the telescoping drawer slide assemblies back in.

Install

1. Reconnect the control cable for the upper drawer in ID models.
2. Pull the telescoping drawer slide out fully.
3. Set the back edge of drawer on to the slide. Pull the slide forward so the inverted channel of the tub goes under the tab on the rear of the telescoping drawer slide.
4. Set the front of the drawer down so the square tab on the drawer slide fits into the square hole on the tub.
   

Answer:

Refer to the product Use and Care Guide for further information.