Skip to main content
E-mail This Answer

Sub-Zero Classic Series (BI) Custom Grille Panel Installation and Removal 

Topics:

  • How does a Classic series (BI) flush inset, overlay, or framed grille panel get installed?
  • Does the grille need to be disassembled to install a custom panel?
  • Instructions to install flush inset, overlay, or framed louvered grille panels

Answer:

Sub-Zero Classic Series (BI) Installation - Panel Installation

To install a custom panel on a Classic series product:​

1. Remove bottom grille frame by removing the lower two corner screws from each side of grille assembly.
2. Slide custom panel into frame.
3. Reattach the bottom grille frame by sliding corner brackets back into position.
4. Install the four corner screws.
5. To remove a custom panel on a Classic series product, reverse the steps above.

Add the grille frame accessory to a stainless steel model to create the look of stainless steel wrapped doors with a custom grille, if desired.

Refer to the product Installation Guide for further installation information. Contact a Factory Certified Installer for further installation information.

Related Questions

DID THIS ANSWER YOUR QUESTION?

Need further assistance? Contact Customer Care at 800.222.7820 or provide your information below and request a Customer Care representative contact you.

Ask Your Question

We're standing by with answers

Whether you're shopping for appliances or have questions about those you already own, we've got the resources you need. Talk directly to a customer care expert at the Sub-Zero, Wolf, and Cove service center, or connect with an appliance consultant at an official showroom near you. Get quick answers online, or reach a certified service provider or installer. And much more.

 

Call us at (800) 222-7820